CAP-2-20 CAP-50-8

large adjustable pivot clamp

Used to hold parts vertically or horizontally with 4-axis rotation. Especially good for clamping sheetmetal and plastic parts up.

	CMC-4

micro center

Has adjustability to hold cylindrical parts up to 26mm in length and 25mm dia. (or smaller) using a female or male tapered pin. You can gain access around the part for touch probing with your CMM or viewing with your vision system.

	CVM-4, CVM-20 CVM-B-4, CVM-B-20

micro vise clamp

Ideal for holding parts horizontally or vertically with
minimum contact on the part made with a V notch in
both directions for holding cylindrical and tubular parts
as well. Micro vise clamp sold with or without base.

	CJR-3-4

rotating 3-jaw clamp

For clamping parts on ID and OD, the rotating 3-jaw clamp can be locked into position on the part then rotated to a marked increment to help locate the rotation of the part for measurement. The rotating 3-jaw clamp can accommodate 7/8” dia. up to 3-1/8” dia.

	CSPS-1210-4 CSPS-751-20

spring pusher standoff clamp

Designed for fixturing small parts in tight or compact space. Ideal for positioning parts and for profile clamping with maintaining constant pressure on part, minimizing fixturing space.

	CT-250-275-20

tension clamp

For quick and easy clamping.

	CPT-250-225-20

positional tension clamp

Allows locking the tension clamp rotational position to avoid probing interferences from one time to the next.

	CTT-250-275-20

soft tip tension clamp

With rubber coated tips used for holding parts without scratching or marring the surface of a part.

	CW-50-50-4

spring wire clamp

For light clamping of small parts minimizing the contact area on a part and for least possible obstruction on vision machines.

	CWT-2-2-20

soft tip spring wire clamp

With rubber coated tips for light clamping of small parts minimizing the contact area on a part and for least possible obstruction on vision machines.

	CTB-1-20

tension clamp bracket

To hold a tension clamp on an angle.

	CH-525-20 CH-350-20

hold down clamp

For more clamping force

	CP-4

pusher clamp

To push a part against standoffs or into corner.

	CSP-20

screw pusher clamp

For pushing and holding a part against stops by way of screwing thumbscrew in and out to release pressure on part.

	CMV-20

mini vise

The updated mini vise now has notched jaws that are ideal for clamping on a small area of a part or around a diameter. The vise can be rotated 360 degrees and then locked into position.

	CJ-3-20

3-jaw clamp

For holding round parts at one end or in the middle, allowing the probe to measure or scan completely around the part without interference. The 3-jaw clamp can be mounted to a base plate in a vertical or horizontal position. The standard aluminum jaws allow parts to be clamped on outside or inside diameters ranging from .06"(1.5mm) to 2.63"(66mm). Optional Delrin jaws are available for non-marring clamping.

	CPC-6A

CMM plate clamp

Non-marring setup clamp for securing fixture bases to a CMM. Please specify desired bolt thread: 1/4-20, M6, M8, M10, or M12.

	CC-25-20

centers

For holding cylindrical parts at each end on their inside diameters. These are ideal for vision machine applications to allow complete visibility of the part.